Service ResetService Reset
  • Home
  • Guides
  • Tools
    • Tire Pressure Calculator
    • Check DTC Codes
    • Request a Guide
    • Wheel Offset Calculator
    • Tire Size Comparison
    • Tire Pressure Converter
    • Torque Converter
    • Coolant & Antifreeze Mix
  • Blog
  • About
  • FAQ
  • Contact Us
  • Home
  • Guides
  • Tools
    • Tire Pressure Calculator
    • Check DTC Codes
    • Request a Guide
    • Wheel Offset Calculator
    • Tire Size Comparison
    • Tire Pressure Converter
    • Torque Converter
    • Coolant & Antifreeze Mix
  • Blog
  • About
  • FAQ
  • Contact Us
Home/Nissan/Quest/Mk4 (RE52) 2011-2017/Replace the Intelligent Key Battery

Replace the Intelligent Key Battery

Reviewed by the Service Reset editor · Updated September 7, 2026 · How we verify

These instructions apply to the Nissan Quest Mk4 (RE52) 2011-2017.
For other models, please choose your vehicle here.

When the Intelligent Key on your Nissan Quest (RE52, 2011–2017) only works up close, or a key battery-discharge indicator shows on the display, the coin cell inside is running down. Replacing it takes a couple of minutes and one inexpensive battery.

The Battery You Need

The RE52 Quest Intelligent Key takes a single CR2025 3-volt lithium coin cell (or equivalent). A dashboard Intelligent Key battery-discharge indicator is your cue to change it before it dies completely.

Replacing the Cell

  1. Slide out the mechanical key from the fob — the release helps you split the case.
  2. Ease the two halves apart at the seam with a small flat screwdriver wrapped in tape.
  3. Lift out the old cell, noting which face points up.
  4. Fit the new CR2025 the same way round, keeping fingers, dust and oil off the cell and contacts.
  5. Align the two halves and click the case back together, then slide the mechanical key home.
  6. Press a button, or start the van, to confirm the key is recognised again.

If It Still Will Not Work

Check the cell is the right way up, seated firmly, and the contacts are clean. If a completely flat key stops the Quest recognising it, you can still start the van by touching the key to the push-button ignition switch — see our dead-key-fob start guide — then fit a fresh cell.

Frequently Asked Questions

Which battery does the RE52 Quest key use? A CR2025 lithium coin cell, or an equivalent brand.

Do I have to reprogram the key afterwards? No — swapping the cell does not erase the programming.

What is the key battery-discharge indicator? A dashboard message that appears when the Intelligent Key’s coin cell is low — fit a new CR2025 promptly.

Can I still drive with a dead key? Yes — touch the key to the ignition switch and start with the brake pressed.

Chasing another niggle on your Nissan? Our sister site autodtcs.com covers engine trouble codes when a warning light appears.

Independent guide — not affiliated with Nissan. Always follow your official service manual and safety precautions. Read our full disclaimer.

Related Articles
  • Reset the Maintenance Interval Reminder
  • Reset the Tire Pressure Warning Light
  • Disconnect and Reconnect the Battery Safely
  • Relearn the Idle Air Volume Without a Scan Tool
  • Start the Engine With a Dead Key Fob
  • Understand the Anti-Theft Security Light

On This Page: [hide]

The Battery You Need

Replacing the Cell

If It Still Will Not Work

Frequently Asked Questions

Service Reset

Independent step-by-step car reset & maintenance guides – not affiliated with any manufacturer. All trademarks belong to their respective owners.

© 2026 ServiceReset.net. All rights reserved.

POPULAR BRANDS
Toyota · Volkswagen · BMW · Ford · Audi · Mercedes · Nissan · Kia
EXPLORE
  • Guides
  • Blog
  • About
  • Contact
TOOLS
  • Dashboard Warning Lights
  • Tire Pressure Calculator
  • Tools
  • FAQ
  • Request a Guide
LEGAL
  • Privacy Policy
  • Terms of Use
  • Disclaimer
  • YouTube
  • Pinterest