• Home
  • Guides
  • Tools
    • Tire Pressure Calculator
    • Check DTC Codes
    • Request a Guide
  • Blog
  • About
  • FAQ
  • Contact Us
  • Home
  • Guides
  • Tools
    • Tire Pressure Calculator
    • Check DTC Codes
    • Request a Guide
  • Blog
  • About
  • FAQ
  • Contact Us
Home/Honda/CR-V/Mk5 (RW/RT) 2018-2023/Reset the Tyre Pressure Monitor (TPMS)

Reset the Tyre Pressure Monitor (TPMS)

Reviewed by the Service Reset editor · Updated August 22, 2026 · How we verify
Quick referenceToolsNoneTime~5 minMethodMenu reset or drive to relearn

These instructions apply to the Honda CR-V Mk5 (RW/RT) 2018-2023.
For other models, please choose your vehicle here.

If the tyre-pressure warning is on in your Honda CR-V Mk5 (RW/RT, 2018–2023) after adjusting pressures or changing wheels, you need to recalibrate. The CR-V uses Honda’s Deflation Warning System — it works from the ABS wheel sensors rather than valve sensors — so you calibrate it and then drive. Here’s how.

How the CR-V’s System Works

Instead of a sensor in each wheel, the CR-V compares how fast the wheels turn. A softer tyre is fractionally smaller and turns faster, and the car flags it. Because it’s comparing wheels, you must calibrate after any pressure change.

How to Recalibrate the CR-V Mk5 TPMS

  1. Set all four tyres to the correct pressure cold — the figures are on the label in the driver’s door opening.
  2. Touchscreen cars: select ‘Home’ → ‘Settings’ → ‘Vehicle’ → ‘TPMS’ → ‘Calibrate’.
  3. Cars with a TPMS button: press and hold the TPMS button for about 4 seconds until the warning light flashes twice.
  4. Drive normally — the system finishes calibrating over the next stretch and the warning clears.

If the Warning Stays On

  • Re-check every tyre, including the spare if it’s a monitored full-size wheel.
  • One tyre noticeably low — look for a slow puncture; the system is doing its job.
  • It flashes then stays on — a flashing TPMS light points to a system fault; have it scanned.

Frequently Asked Questions

How do I reset the tyre pressure light on a Honda CR-V?

Set the pressures, then calibrate — touchscreen Settings → Vehicle → TPMS → Calibrate, or hold the TPMS button ~4 seconds — and drive.

Do I need a tool?

No — it’s a deflation-warning system, so calibrate in the menu/button and drive.

Why did the light come on in the cold?

Pressure drops as temperature falls. Top up to the door-label figure and recalibrate.

Dashboard tyre-pressure (TPMS) readout.
Dashboard tyre-pressure readout (illustrative). Adapted from a photo by WillisMoon via Wikimedia Commons, CC BY 4.0.

The light keeps flashing — is that a fault?

A persistent flash usually means a system fault rather than low pressure — have it diagnosed.

If a fault code is stored, look it up on autodtcs.com. To clear a service reminder, see our CR-V Mk5 service reset guide.

Independent guide — not affiliated with Honda. Always follow your official service manual and safety precautions. Read our full disclaimer.

Tyre tools: Changed tyre size or just adjusting pressures? Use our free non-stock tyre pressure calculator, bar/PSI/kPa converter and tyre size comparison tool.
Related Articles
  • Put the Electronic Parking Brake into Service Mode
  • Start the Car With a Dead Key Fob Battery
  • Read the Climate Control Self-Diagnostic Codes
  • Reset a Frozen Infotainment Screen
  • Enable or Disable the Idle-Stop System
  • Replace the Key Fob Battery

Service Reset

Step-by-step reset and maintenance guides for all major car brands. Independent resource – not affiliated with any car manufacturer. All trademarks and logos are the property of their respective owners and are used for identification purposes only.

© 2026 ServiceReset.net. All rights reserved.

POPULAR BRANDS
Toyota · Volkswagen · BMW · Ford · Audi · Mercedes · Nissan · Peugeot · Vauxhall · Kia
NAVIGATION
  • Home
  • Guides
  • Tools
  • Tire Pressure Calculator
  • Blog
  • About
  • FAQ
  • Request a Guide
  • Contact
LEGAL
  • Privacy Policy
  • Terms of Use
  • Disclaimer
SOCIAL
  • YouTube