These instructions apply to the Lexus RX Mk3 (AL10) 2009-2015.
For other models, please choose your vehicle here.
If the gear selector in your Lexus RX (2009–2015) — the AL10 RX 450h hybrid or petrol RX 350 — is stuck in P and won’t move, you can free it with the shift-lock override. This normally happens when the 12 V battery is flat or there is a fault in the shift-lock system, and you need to roll the car onto a trailer or out of the way. It is an emergency measure, not a repair — have the cause checked afterward.
Why the Lever Locks in Park
The RX has a shift-lock that keeps the lever in P until the car is powered on and you press the brake. If the 12 V battery is dead, or a brake-switch or shift-lock fault is present, the lever stays locked and ordinary braking won’t release it. The override mechanically bypasses the lock just long enough to select another gear.
On the RX 450h the 12 V battery is in the luggage compartment, so a flat aux battery is a common reason the lever won’t move even though the car looks dead. The override works the same on both the hybrid and the petrol RX 350.
Before You Begin
- Set the parking brake so the car can’t roll once the lever leaves P.
- Have the smart key with you — you’ll switch the car to accessory mode.
- Find the shift-lock override: a small slot beside the gear lever, usually under a removable trim cap marked with an arrow.
- No tools are needed beyond a small flat tool to lift the cap and press the button.
Releasing the Shift Lock

- Apply the parking brake.
- Switch the car to ACCESSORY mode — press the POWER (or ENGINE START STOP) button once without your foot on the brake, so the car powers up but does not go to READY.
- Press and hold the brake pedal.
- Press the shift-lock override button (lift the trim cap beside the lever first). While it is held down, move the lever out of P into N.
If the Lever Still Won’t Move
- Keep the override pressed the whole time you move the lever — releasing it re-locks the lever.
- Make sure the brake pedal is pressed and the car is in accessory mode, not fully off.
- Flat 12 V battery? Jump-start or charge it — a dead aux battery is the most common cause, and once it has power the lever often releases normally.
- Do not force the lever. If it won’t move with the override pressed, stop and have the shift-lock system inspected.
After You’ve Freed the Lever
Only use the override to get the car moving or loaded; it is not a way to drive around a fault. If the lever locked because of a flat 12 V battery, deal with the battery. If it locked with a healthy battery, a brake-light switch or shift-lock fault is likely and will usually store a diagnostic code.
Frequently Asked Questions
Where is the shift-lock override on a Lexus RX (2009–2015)?
It’s a small slot beside the gear lever, under a removable trim cap usually marked with an arrow. Lift the cap and press the button inside while holding the brake to move the lever out of P.
Why is my RX stuck in Park?
Most often a flat 12 V battery (in the boot on the 450h), or a brake-light-switch or shift-lock fault. The override frees the lever as an emergency measure; the underlying cause still needs fixing.
Is it safe to use the shift-lock override?
Yes, as a short-term way to move or trailer the car — set the parking brake first so it can’t roll. It is not a substitute for repairing a flat battery or a shift-lock fault.
Does the hybrid RX 450h release differently from the petrol RX 350?
No — the override sequence is identical. The only difference is the 450h’s 12 V battery is in the luggage area, so a flat aux battery there is a common trigger.
If a warning light appeared with the stuck lever, decode the stored code on autodtcs.com.
Independent guide — not affiliated with Lexus. Always follow your official service manual and safety precautions. Read our full disclaimer.