These instructions apply to the Vauxhall Insignia Mk1 (G09) 2008-2017.
For other models, please choose your vehicle here.
If your Vauxhall Insignia A remote is getting weak or only works up close, the coin cell inside needs replacing. The folding (switchblade) key uses a common CR2032 battery and takes a couple of minutes.
Replace the key fob battery
- Press the button to flip out the metal key blade.
- Split the fob along its seam (there is usually a slot for a small coin or flat screwdriver near the keyring eye).
- Lift out the old CR2032 cell, noting which way up it sits.
- Fit the new CR2032 the same way round (+ side as before), keeping fingers off the flat faces.
- Click the two halves back together and refit the key blade.
If the remote needs resynchronizing
If the buttons don’t work right after the change, unlock the driver’s door with the metal blade, get in and switch the ignition on — this resynchronizes the remote with the car.
What battery does the Insignia key take?
The folding remote key uses a CR2032 3-volt lithium coin cell. Keyless-entry fobs on higher trims also typically use a CR2032; check the cell you remove and match it exactly.
Do I need the car to reprogram the key after a battery change?
No — a battery change doesn’t erase the key. Reprogramming is only needed for a brand-new or replacement key, which is a dealer or auto-locksmith job.
Independent guide — not affiliated with Vauxhall. Always follow your official service manual and safety precautions. Read our full disclaimer.