These instructions apply to the Chevrolet Silverado 1500 Mk4 (T1XX) 2019-Present.
For other models, please choose your vehicle here.
The 2019–Present Chevrolet Silverado 1500 (T1XX) has a direct TPMS with a sensor in every wheel (the spare is not monitored). After a tire rotation or a sensor swap the truck has to relearn which sensor sits at which corner. On trucks with the uplevel DIC you do it yourself in Tire Learning mode with an inexpensive GM relearn tool. This is the US-market procedure, shared with the GMC Sierra.
- Set all four tires to the correct cold pressure (see the table below). Apply the parking brake and turn the ignition ON without starting the engine.
- Scroll the DIC to the tire-pressure screen (uplevel DIC: the buttons on the right of the steering wheel; base DIC: the trip-odometer reset stem).
- Press and hold the thumbwheel / Set-Reset control (or the trip-odometer stem for about 5 seconds) and confirm yes. The horn sounds twice and TIRE LEARNING ACTIVE shows — the system starts at the driver-front wheel.
- Hold a GM TPMS relearn tool flat against the sidewall near the driver-front valve stem and press it until the horn chirps — that sensor is learned.
- Repeat in order — passenger-front, then passenger-rear, then driver-rear — waiting for the chirp at each.
- After the driver-rear the horn sounds twice: learning is complete. Switch the ignition off, then set all four pressures to the placard figure.
You have two minutes for the first wheel and five minutes overall; if it times out, start again from Tire Learning.
Chevrolet Silverado 1500 tire pressures
The 1500’s recommended cold pressures depend on the fitted tire size. GM prints the exact figures for your truck on the Tire and Loading Information label on the driver-side center (B) pillar — that placard is the authority. Typical factory figures by size are:
| Tire size | Front (cold) | Rear (cold) |
|---|---|---|
| 255/70R17, 265/70R17 (P-metric) | 35 psi | 35 psi |
| 265/65R18 | 35 psi | 35 psi |
| 275/60R20, 275/55R20, 275/50R22 | 32 psi | 32 psi |
| LT265/70R17, LT275/65R18 (heavy-duty / tow) | 45 psi | 45 psi |
Set them cold (truck parked three hours or driven under a mile). If your placard differs from the table, follow the placard.
FAQ
Do I need a tool?
Yes — a GM-compatible TPMS relearn tool (about $15) triggers each sensor in turn. It is a cheap DIY buy, not a dealer-only item. GM’s own tool is sold through its tool supplier; equivalents work the same way.
My DIC has no Tire Learning option.
Base trucks with the low-level DIC don’t expose Tire Learning — those need a shop or a scan tool to relearn.
What order do the wheels go in?
Driver-front, passenger-front, passenger-rear, driver-rear.
The light is still on afterward.
Re-check all four pressures cold against the placard and repeat the relearn. A sensor with a flat battery won’t report and will need replacing.
The Silverado 1500 shares its platform and running gear with the GMC Sierra 1500, so this procedure is identical on both — see our GMC Sierra 1500 guides.
If your truck stores a fault code with the warning light, look it up on autodtcs.com.
Independent guide — not affiliated with Chevrolet. Always follow your official service manual and safety precautions. Read our full disclaimer.