These instructions apply to the Vauxhall Insignia Mk1 (G09) 2008-2017.
For other models, please choose your vehicle here.
Vauxhall Insignia A models fitted with tire pressure monitoring warn you when a tire loses pressure. After you correct the pressures or change a wheel, the system relearns by driving — it does not show live per-wheel pressures, so set the correct cold figures and let it re-reference.
Reset the tire pressure warning
- Set all tires to the correct cold pressure from the table below (confirm against the placard on the driver’s door pillar or inside the fuel flap).
- Switch the ignition on.
- Drive the car for about 9 minutes at a steady speed above 25 mph (40 km/h).
- The warning light goes out once the system has relearned the new pressures.
Vauxhall Insignia A tire pressures (2008–2017)
Normal / unladen cold pressures. Always use the placard on your own car, as figures vary with wheel size, load and year.
| Tire size | Front | Rear |
|---|---|---|
| 215/60 R16 | 32 psi (2.2 bar) | 30 psi (2.1 bar) |
| 225/55 R17 | 32 psi (2.2 bar) | 30 psi (2.1 bar) |
| 245/45 R18 | 32 psi (2.2 bar) | 30 psi (2.1 bar) |
| 245/35 R20 | 33 psi (2.3 bar) | 35 psi (2.4 bar) |
Add roughly 3 psi (0.2 bar) for a full load, as shown on the placard.
Why won’t my Insignia tire pressure light go out?
The warning only clears once every tire is at the right pressure and the car has been driven far enough to relearn. A tire that is still slightly low, or a failed sensor on cars with direct sensors, keeps the light on. Check all pressures cold, including the spare.
Does my Insignia have tire pressure sensors?
Not every early Insignia A has monitoring — it became standard on new cars later in the run. If the car was built before late 2014 and has no tire-pressure menu, it likely relies on the ABS-based warning or has no system at all.
Independent guide — not affiliated with Vauxhall. Always follow your official service manual and safety precautions. Read our full disclaimer.