These instructions apply to the Vauxhall Insignia Mk1 (G09) 2008-2017.
For other models, please choose your vehicle here.
If the 12-volt battery is flat on a Vauxhall Insignia A, you can jump-start it from another vehicle or a jump pack. The battery is in the engine compartment, so you connect directly to its terminals — there is no remote jump point on this car.
Jump-start the Insignia
- Park the donor car close but not touching, and switch both cars off.
- Connect the red lead to the donor battery positive (+), then to the Insignia’s positive (+) terminal.
- Connect the black lead to the donor negative (−), then to a solid, unpainted ground point on the Insignia’s engine — not the flat battery’s negative post — keeping the connection well away from the battery.
- Start the donor car and let it run for a couple of minutes.
- Start the Insignia. Once running, remove the leads in reverse order (ground first).
- Drive or run the engine for 20–30 minutes to recharge the battery.
Use proper jumper cables of at least 16 mm² cross-section (25 mm² for diesels), and never let the clamps touch each other.
Why connect the earth lead to the engine, not the battery?
Grounding to the engine away from the battery keeps any spark clear of the hydrogen gas a charging battery gives off, reducing the risk of igniting it. It is the method Vauxhall specifies for the Insignia.
The car died again after jump-starting — what now?
If it will not hold a charge, the battery is likely at the end of its life or there is a parasitic drain. Have the battery and charging system tested; repeated flat batteries also upset the electronic parking brake and stop/start.
Independent guide — not affiliated with Vauxhall. Always follow your official service manual and safety precautions. Read our full disclaimer.