These instructions apply to the Chevrolet Silverado 1500 Mk2 (GMT900) 2007-2013.
For other models, please choose your vehicle here.
You may need to disconnect the 12-volt battery on your 2007-2013 Chevrolet Silverado 1500 (GMT900) for bodywork, electrical repairs, or long-term storage. The battery is a maintenance-free unit in the engine compartment, and disconnecting it safely takes a few simple precautions.
Where is the battery?
The 12-volt battery sits in the engine compartment (shown in the under-hood overview in your owner’s manual). For convenience there is also a remote positive (+) terminal under a red plastic cover near the underhood fuse block, used for jump-starting – but to disconnect the battery you work at the battery itself.
How to disconnect the battery
- Turn everything off, remove the key, and wait at least a minute or two. An airbag can still deploy for up to about 10 seconds after the ignition is switched off, so give the system time to power down.
- Open the hood and locate the battery.
- Loosen the clamp on the black negative (-) cable first and lift it off the post. Tuck it aside so it can’t spring back onto the terminal.
- If you are removing the battery, loosen and remove the red positive (+) cable next, then the hold-down clamp.
- For long-term storage you can simply remove the negative (-) cable to stop the battery draining.
How to reconnect
- Refit the battery and hold-down if it was removed.
- Connect the positive (+) cable first, then the negative (-) cable, and tighten both clamps snugly.
- Switch on the ignition and check that the warning lights behave normally.
What to expect after reconnecting
The clock and radio presets will need resetting, and the Driver Information Center may need a moment to repopulate. Note that the power rear liftgate/liftglass (on SUV-bodied siblings) and some convenience features won’t operate while the battery is disconnected or very low – they resume once the battery is reconnected and charged. The Silverado owner’s manual does not list a power-window or module relearn for these trucks, so none is required.
Frequently asked questions
Which battery terminal do I disconnect first on a Silverado?
Always the negative (-) terminal first when disconnecting, and reconnect it last. This avoids a short if your wrench touches metal while the positive side is still live.
Will disconnecting the battery cause problems?
No lasting problems – you will just need to reset the clock and radio presets. Wait a couple of minutes after switching off before disconnecting so the airbag system powers down safely.
Where is the jump-start terminal on a GMT900 Silverado?
There is a remote positive (+) post under a red cover near the underhood fuse block; use it with the engine ground point for jump-starting. The battery’s own terminals are used for disconnecting or replacing the battery.
Independent guide — not affiliated with Chevrolet. Always follow your official service manual and safety precautions. Read our full disclaimer.