These instructions apply to the Hyundai i30 Mk2 (GD) 2012-2017.
For other models, please choose your vehicle here.
The Hyundai i30 Mk2 (GD, 2012–2017) uses a separate H7 bulb for dipped beam and an H1 bulb for main beam in the halogen headlamps. On the GD the dipped-beam bulb is behind the headlamp, and access is tight — on most cars you actually unbolt the headlamp unit to reach it. This guide lists the i30’s bulb types and the manufacturer’s method for changing a front bulb.
i30 GD Bulb Types
- Dipped (low) beam: H7, 55 W
- Main (high) beam: H1, 55 W
- Front turn signal / position light: 21/5 W
- Front fog lamp: 27 W (H27/881-type), if fitted
- Side repeater (in the mirror): LED, or 5 W on the body
- Rear turn signal: 21 W · stop/tail: 21/5 W · reverse: 16 W · rear fog: 21/5 W
- High-level brake light: LED · number-plate light: 5 W
Some facelift and higher trims have projector or LED-signature headlamps; the bulb types above still apply to the halogen units, but a full-LED headlamp has no replaceable bulb.
How to Change a Front Headlight Bulb
- Switch the lights and ignition off and open the bonnet.
- For the dipped-beam (H7) bulb, Hyundai’s method is to unbolt and withdraw the headlamp unit (three bolts) to reach the back of it — access past the battery and washer bottle is too tight otherwise.
- Turn the round cover on the back of the headlamp anticlockwise and remove it.
- Unplug the bulb connector, then release the wire retaining clip by pressing its end and swinging it clear.
- Withdraw the old bulb. Fit the new one without touching the glass — skin oil creates a hot spot that shortens bulb life. Hold it by the metal base or use a cloth.
- Clip the retainer back, reconnect the plug, refit the cover, and refit the headlamp. Test the light before closing the bonnet.
Always replace bulbs in pairs so both sides match in brightness. If the headlamp was removed, check the beam aim afterwards and have it adjusted if needed.
Frequently Asked Questions
What headlight bulb does the Hyundai i30 GD take?
An H7 (55 W) for dipped beam and a separate H1 (55 W) for main beam on the halogen cars.
Why is the i30 dipped-beam bulb so hard to reach?
The battery and washer bottle sit right behind the headlamps, so there’s very little room. Hyundai’s own procedure is to unbolt the headlamp unit (three bolts) and draw it forward to get at the bulb.
Can I replace the LED headlight bulbs myself?
No. Full-LED headlamps are sealed modules with no owner-replaceable bulb — that’s a dealer or specialist repair.
Why shouldn’t I touch the glass of a new bulb?
Oil from your fingers causes a hot spot that can fail the bulb early. Handle halogen bulbs by the base or with a clean cloth.
If a bulb-out warning or lighting code is stored, look it up on autodtcs.com.
Independent guide — not affiliated with Hyundai. Always follow your official service manual and safety precautions. Read our full disclaimer.