These instructions apply to the Chevrolet Impala Mk10 2014-2020.
For other models, please choose your vehicle here.
The 2014–2020 Chevrolet Impala shows CHANGE ENGINE OIL SOON via the GM Oil Life System. After an oil and filter change you reset it from the Driver Information Center. This is the US-market procedure.
DIC button method
- Use the steering-wheel DIC controls to display REMAINING OIL LIFE.
- Press and hold the ✓ (set) button a few seconds until the message clears and oil life reads 100%.
Accelerator-pedal method
- Ignition ON, engine off.
- Fully press and release the accelerator pedal three times within five seconds.
FAQ
What oil does it take?
dexos1 oil — 5W-20 on the 2.5L four (5.0 qt), 5W-30 on the 3.6L V6 (6.0 qt).
Reset after every change?
Yes — the system must be reset at each oil change; if reset by accident, change the oil within 3,000 miles.
It didn’t take.
Hold the ✓ button with REMAINING OIL LIFE showing; repeat if CHANGE ENGINE OIL SOON returns.
If your Impala stores a fault code with the warning light, look it up on autodtcs.com.
Independent guide — not affiliated with Chevrolet. Always follow your official service manual and safety precautions. Read our full disclaimer.