These instructions apply to the Chevrolet Silverado 1500 Mk2 (GMT900) 2007-2013.
For other models, please choose your vehicle here.
The 2007-2013 Chevrolet Silverado 1500 (GMT900) uses a direct tire pressure monitoring system (TPMS) with a sensor in each wheel. After you rotate the tires or fit a different wheel, the system needs to relearn which sensor is at which corner so the display shows the right pressure for each tire. You can do this yourself with just the key fob – no scan tool required.
Recommended tire pressures
The GMT900 Silverado 1500 came on several original tire sizes; your exact cold pressures are printed on the Tire and Loading Information placard on the driver’s door B-pillar (below the latch). On the half-ton 1500 these are commonly 35 psi front and rear – always set to what your own placard says, as HD, off-road and towing packages differ.
| Original tire size | Typical cold pressure (per placard) |
|---|---|
| P265/70 R17 | 35 psi (2.4 bar) front and rear |
| P265/65 R18 | 35 psi (2.4 bar) front and rear |
| P275/55 R20 | 35 psi (2.4 bar) front and rear |
Set pressures cold. Your truck’s placard is the final authority – follow it if it differs from the figures above.
How to relearn the TPMS sensors
You will relearn the four wheels in order: driver front, passenger front, passenger rear, driver rear. You have two minutes to start the first wheel and five minutes to finish all four.
- Set the parking brake.
- Turn the ignition to ON/RUN with the engine off.
- Press the key fob’s LOCK and UNLOCK buttons at the same time for about five seconds. The horn sounds twice and “TIRE LEARNING ACTIVE” shows on the DIC – the system is now in relearn mode.
- Go to the driver’s-side front tire. Remove the valve cap and briefly let air out (or add air) for about five seconds, until you hear a horn chirp – that confirms the sensor is matched. The chirp can take up to 30 seconds.
- Repeat in order: passenger front, then passenger rear, then driver rear.
- After the driver’s-rear tire is matched, the horn sounds twice to show the relearn is complete.
- Turn the ignition off, set all four tires to the correct cold pressure, and refit the valve caps.
Frequently asked questions
How do I reset the TPMS on a 2007-2013 Silverado after rotating the tires?
Put the system in relearn mode (ignition on, hold LOCK + UNLOCK on the fob for 5 seconds until the horn sounds twice), then activate each sensor in turn – driver front, passenger front, passenger rear, driver rear – by letting a little air out until the horn chirps.
Why is my Silverado TPMS light still on?
A steady light usually means a tire is low – set all four to the placard pressure. If it stays on after that, the sensors may need relearning (above), or a sensor battery may be dead (they last around 5-7 years).
Do I need a TPMS tool to relearn the sensors?
No. The key-fob relearn above works without any tool – you activate each sensor by changing its pressure slightly. A TPMS tool just makes it faster and is what a shop would use.
Independent guide — not affiliated with Chevrolet. Always follow your official service manual and safety precautions. Read our full disclaimer.