These instructions apply to the Suzuki Ignis Mk3 (ATK) 2016-Present.
For other models, please choose your vehicle here.
Your Suzuki Ignis Mk3 (ATK, 2016–present) has an engine start/stop (ENG A-STOP) system that switches the engine off when you come to a halt and restarts it as you pull away. It saves fuel, but some drivers prefer it off in stop-go traffic. This guide shows how to switch it off, and why it sometimes won’t engage.
How Start/Stop Works on the Ignis
When you brake to a stop (and conditions allow), the system shuts the engine down. Lifting the brake or pressing the clutch restarts it. On Smart Hybrid (SHVS) cars the integrated starter-generator makes the restart especially quick and smooth.
How to Switch It Off
- With the engine running, find the ENG A-STOP OFF button on the dashboard (an “A” inside a circular arrow).
- Press it once. The warning light illuminates to confirm the system is off.
- The engine now idles normally at a stop.
How to Switch It Back On
Press the button again so the light goes out, or simply restart the car — the system defaults back to ON every time you switch the ignition off and on.
Why It Sometimes Won’t Activate
- The engine is not yet up to temperature.
- The battery charge is low — common after a battery change or short trips.
- Cabin heating or demisting needs the engine running.
- The steering is turned, or the car is on a slope.
If it stopped working entirely after a battery disconnection, the battery needs to recharge — see our Ignis battery guide.
Frequently Asked Questions
Does the Ignis remember my start/stop setting?
No — it resets to ON every time you restart the car. Press the OFF button each drive if you prefer it disabled.
Is it bad to keep using start/stop?
No. The Ignis’s starter and battery are built for it, and on SHVS cars the hybrid system handles most restarts. It skips stops when the battery is low to protect itself.
Why did it stop working after a flat battery?
It only runs when the battery is well charged. After a jump-start or battery change it stays dormant until charge recovers; a few longer drives usually restore it.
Can I turn it off permanently?
Not from the dashboard — the button is per-drive only. A permanent change would need dealer-level configuration.
If a warning light appeared alongside the fault, look up the code on autodtcs.com. To clear a service reminder, see our Suzuki Ignis service indicator reset guide.
Independent guide — not affiliated with Suzuki. Always follow your official service manual and safety precautions. Read our full disclaimer.