These instructions apply to the Renault Clio Mk4 (X98) 2012-2019. For other models, please choose your vehicle here.
Last updated:
The automatic stop/start system on the Renault Clio Mk4 (X98, 2012–2019) switches the engine off when you stop and restarts it as you pull away. It trims fuel use in town, but many owners find it intrusive in traffic. This guide shows how to turn stop/start off on a Clio Mk4, the second way to suppress it, and why the car re-enables it every drive.
How Stop/Start Works on the Clio
The system only stops the engine when a set of conditions is met: the car is stationary, the engine is warm, the battery is well charged, the climate demand is satisfied, and (on a manual) the car is in neutral with the clutch up. On a cold morning or with the heater on full it may do nothing — that is the system working as designed. When it cuts the engine, a green “A” / stop-start symbol appears in the display.
Method 1 — The Stop/Start Button
- With the engine running, find the stop/start button marked with an “A” inside a circular arrow, on the centre console or dash.
- Press the button once.
- The warning light in the button illuminates and the display shows a message confirming the system is off.
- The engine will now idle normally at a standstill.
Press the button again to switch stop/start back on.
Method 2 — Seat Belt and Door Interlock
The Clio will not auto-stop the engine unless the driver’s seat belt is fastened and the driver’s door is closed. As a quick workaround:
- With the driver’s seat belt unbuckled, the engine will not enter auto-stop.
- Opening the driver’s door also inhibits the system.
Stay belted while driving — this just explains why the system sometimes seems to do nothing.
Why It Comes Back On Every Drive
The button only disables stop/start for the current drive cycle. Switch the ignition off and on and the Clio re-enables it by default, because the system counts toward the car’s official emissions figures. There is no menu setting to make “off” permanent — a permanent change requires recoding the relevant module with a Renault-capable diagnostic tool, which is an at-your-own-risk modification.
Stop/Start Stopped Working? Check These First
- Battery state of charge low — the most common reason; the system protects the battery by not stopping the engine.
- Battery replaced but not registered — the charging system keeps it in a protective mode.
- Engine or cabin not yet at temperature — climate demand keeps the engine running.
- A stored fault — a battery-management or engine code can disable stop/start silently. Check what a code means on autodtcs.com.
Frequently Asked Questions
Can I permanently disable stop/start on a Clio Mk4 without coding?
No — the button only lasts for the current drive. A permanent default change requires recoding with a Renault diagnostic tool.
Is it bad for the engine to keep restarting?
No. The starter and battery are designed for it, and the system blocks auto-stop until the engine is warm.
Does turning it off use more fuel?
Only marginally, and only in stop-and-go traffic. On the open road it makes no difference.
Why does the “A” symbol have a line through it?
That means auto-stop is temporarily unavailable because a condition is not met (cold engine, low battery, climate demand). It resumes once conditions allow.
If a low battery is the cause, our Clio Mk4 battery disconnect/reconnect guide covers replacing and resetting it.
Disclaimer: The information on this page is provided for general guidance only. Always follow your official service manual and safety precautions when working on your vehicle. We are not responsible for errors, omissions, or any damage resulting from the use of this information.
This website is an independent resource and is not affiliated with, endorsed by, or sponsored by Renault. All trademarks and brand names belong to their respective owners.