These instructions apply to the Toyota Corolla Mk11 (E170) 2014-2019.
For other models, please choose your vehicle here.
A flat 12 V battery will stop a 2014–2019 Toyota Corolla cranking. Jump it in order and ground the last clamp to bare metal away from the battery. This is the US-market procedure.
- Park a 12 V donor close but not touching; parking brake on, both ignitions off. Open the hood.
- Red (+) to the Corolla’s positive (+), then to the donor’s positive (+).
- Black (−) to the donor’s negative (−), then to a solid unpainted metal point on the Corolla, away from the battery and moving parts.
- Run the donor at a slightly raised idle ~5 minutes, then start the Corolla. Remove the cables in reverse order.
FAQ
Where does the negative clamp go?
Bare, unpainted metal away from the battery — not the dead battery’s negative post.
Can I push-start it?
No — the automatic/CVT can’t be push-started. Use cables or a jump pack.
It won’t hold a charge.
Have the battery and alternator tested.
If your Corolla stores a fault code with the warning light, look it up on autodtcs.com.
Independent guide — not affiliated with Toyota. Always follow your official service manual and safety precautions. Read our full disclaimer.