These instructions apply to the Vauxhall Insignia Mk2 (Z18) 2017-2022.
For other models, please choose your vehicle here.
A flat 12-volt battery on the Vauxhall Insignia B can leave the car dead and the gear selector locked in Park. The battery is in the engine compartment, under a cover, with a positive jump terminal you can reach from under the hood.
Jump-start the Insignia
- Park the donor car close but not touching; switch both off.
- Lift the cover over the Insignia’s positive (+) terminal.
- Connect the red lead to the donor positive (+), then to the Insignia positive (+).
- Connect the black lead to the donor negative (−), then to a solid engine ground point on the Insignia — not the flat battery’s negative post.
- Start the donor car, wait a couple of minutes, then start the Insignia.
- Remove the leads in reverse order and drive for 20–30 minutes to recharge.
My Insignia is stuck in Park after going flat — how do I move it?
A dead battery locks the automatic selector in P. Jump-start it first; if you must move the car before that, use the shift-lock override under the selector cover. Charging the battery usually restores normal operation.
Why does the Insignia keep going flat?
Short journeys, a tired battery, or a parasitic drain are the usual causes, and this generation is sensitive to 12-volt condition — stop/start and the electronic brake act up first. Have the battery and drain tested if it recurs.
Independent guide — not affiliated with Vauxhall. Always follow your official service manual and safety precautions. Read our full disclaimer.