These instructions apply to the Peugeot 208 Mk1 (A9, A91) 2012-2019.
For other models, please choose your vehicle here.
The automatic stop & start system on the Peugeot 208 Mk1 (A9, 2012–2019) cuts the engine when you stop and restarts it as you pull away. Many owners find it intrusive in traffic. Here is how to switch it off, a second way to suppress it, and why the 208 re-enables it every drive.
Before you start
- The stop & start button is marked with an “A” (sometimes “ECO OFF”), on the dash or centre console.
- Auto-stop only triggers when the car is stationary and warm, the battery is well charged, and climate demand is satisfied — on a cold morning or with the heater on full it may do nothing, which is normal.
- A green “A” / ECO symbol appears when the engine has auto-stopped.
Method 1 — The Stop & Start Button
- With the engine running, find the stop & start button — on the 208 it is marked with an “A” (sometimes “ECO OFF”), on the dash or centre console.
- Press the button once.
- The warning light in the button illuminates and the display shows a message confirming the system is off.
- The engine will now idle normally at a standstill.
Press the button again to switch stop & start back on.
Method 2 — Seat Belt and Door Interlock
The 208 will not auto-stop the engine unless the driver’s seat belt is fastened and the driver’s door is closed. As a quick workaround:
- With the driver’s seat belt unbuckled, the engine will not enter auto-stop.
- Opening the driver’s door also inhibits the system.
Stay belted while driving — this just explains why the system sometimes seems to do nothing.
Why It Comes Back On Every Drive
The button only disables stop & start for the current drive cycle. Switch the ignition off and on and the 208 re-enables it by default, because the system counts toward the car’s official emissions figures. There is no menu setting to make “off” permanent — a permanent change requires recoding the relevant module with a Peugeot-capable diagnostic tool, which is an at-your-own-risk modification.
Stop & Start Stopped Working? Check These First
- Battery state of charge low — the most common reason; the system protects the battery by not stopping the engine.
- Battery replaced but not registered — the charging system keeps it in a protective mode.
- Engine or cabin not yet at temperature — climate demand keeps the engine running.
- A stored fault — a battery-management or engine code can disable stop & start silently. Check what a code means on autodtcs.com.
Frequently Asked Questions
Can I permanently disable stop & start on a 208 without coding?
No — the button only lasts for the current drive. A permanent default change requires recoding with a Peugeot diagnostic tool.
Why does the “A” symbol have a line through it?
That means auto-stop is temporarily unavailable because a condition is not met (cold engine, low battery, climate demand). It resumes once conditions allow.
If a low battery is the cause, our 208 battery disconnect/reconnect guide covers replacing and resetting it.
Independent guide — not affiliated with Peugeot. Always follow your official service manual and safety precautions. Read our full disclaimer.