These instructions apply to the Peugeot Traveller Mk1 (K0) 2016-present.
For other models, please choose your vehicle here.
The Peugeot Traveller uses an indirect tire-pressure system that watches each wheel’s rolling speed, so there is no per-wheel PSI display. After you adjust the pressures or change a wheel, you must re-initialize it so it learns the new correct pressures as the reference.
How to reset (re-initialize) the TPMS
- Set all tires to the correct cold pressures for your load — read the label on the driver’s door pillar or inside the fuel flap.
- Switch the ignition on.
- Touchscreen vans: open Driving assistance, select Under-inflation initialisation, then YES. A beep and a confirmation message follow.
- Audio-system vans: open Personalisation–configuration and select Under-inflation initialisation.
- Vans without an audio system: press and hold the TPMS button for about 3 seconds until it beeps.
- Drive normally so the system can learn the new reference pressures.
Because the system is indirect, it only warns of a pressure loss relative to the stored reference — always reset it straight after inflating or swapping tires, or it may warn incorrectly.
Frequently asked questions
Why doesn’t my Traveller show individual tire pressures?
It has an indirect system (no pressure sensors in the wheels), so it monitors wheel speed instead of reading actual PSI. That is normal — it shows a warning, not live numbers.
When do I need to reset it?
After adjusting the pressures, rotating or replacing tires, or fitting the spare — anything that changes the “normal” rolling behavior.
The warning won’t clear — what now?
Re-check and correct all four cold pressures (and the spare), then re-run the initialization. A warning that returns while pressures are correct can indicate a slow leak or a damaged tire.
Independent guide — not affiliated with Peugeot. Always follow your official service manual and safety precautions. Read our full disclaimer.