These instructions apply to the Vauxhall Corsa Mk5 (E/X15) 2014-2019.
For other models, please choose your vehicle here.
The Vauxhall Corsa E (2014–2019) uses an indirect tyre-pressure monitoring system that you re-teach yourself through the Driver Information Centre — no sensors to pair and no tool needed.
Reset it after adjusting the pressures, or after changing or rotating a wheel or tyre.
How to reset the TPMS on a Vauxhall Corsa E
- Set all four tyres to the correct pressure first (see the label in the driver’s door opening or fuel flap).
- Apply the parking brake and turn the ignition key to position 2 — do not start the engine. On automatic cars select P; on an Easytronic select N and wait 5 seconds.
- Press the MENU button on the indicator stalk.
- Scroll to the Vehicle information menu, then select Tyre pressure.
- Press and hold the SET/CLR button until a confirmation message appears on the display.
- Press the button again. Two audible signals confirm the system has been reset.
The warning light may take a few miles of driving above roughly 20 mph for the system to relearn each wheel. If the light stays on after that, re-check the pressures when the tyres are cold and repeat the reset.
Frequently asked questions
Why won’t the Corsa E TPMS light go out?
The pressures are usually still wrong, or the reset was not confirmed. Set every tyre cold to the door-label figure, then run the reset again and drive a short distance.
Does the Corsa E have sensors in the wheels?
Most use an indirect system that reads wheel speed, so there is nothing to pair — the self-relearn above is all that is required.
If a separate warning light is showing alongside the TPMS message, you can identify the fault code on autodtcs.com.
Independent guide — not affiliated with Vauxhall. Always follow your official service manual and safety precautions. Read our full disclaimer.